67
KM192A
3. Install the new bulb into the hous-
ing; then secure with the spring clip.
KM195
4. Connect the three-wire connector to
the bulb; then install the rubber boot.
To replace the taillight/brakelight bulb,
use the following procedure.
1. Remove the two screws and remove
the lens.
KM143B
2. Push the bulb in and turn it counter-
clockwise.
3. Install the new bulb by turning it
clockwise while pushing in.
4. Install the lens. Tighten the two
screws securely.
Fuses
The fuse box (with three active fuses and
one spare fuse) is located under the seat
near the battery.
KM102
NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse cover and lift off;
then remove and replace the fuse.
Tools
A basic tool kit, located under the seat, is
provided with the ATV. Maintain the tool
kit with the ATV at all times.
CAUTION
When replacing the headlight bulb,
be careful not to touch the glass
portion of the bulb. Grasp the new
bulb with a clean cloth.
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Arctic Cat ATV dealer immediately.
Summary of Contents for 300 Utility
Page 72: ...70 Maintenance Record DATE HOURS SERVICE PERFORMED NOTES ...
Page 81: ...79 NOTES ...
Page 82: ...80 NOTES ...