41
LCD Gauge (400)
CF236B
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12-hour mode; the hour meter indi-
cates the total time the ATV has run
and cannot be reset to zero. To set
the clock, use the following proce-
dure.
A. With the ignition switch ON,
press and release the Mode But-
ton until the Clock/Engine Hour
Meter is displayed; then (if nec-
essary) press and release the Set/
Reset Button to select the clock
display.
B. Press and hold the Set/Reset But-
ton until the minutes stop scrolling
and the hour display starts to scroll.
Momentarily release when the cor-
rect hour is displayed; then repeat-
edly press and release the Set/Reset
Button until the correct minutes are
displayed.
NOTE: Clock memory power is
supplied through the 30-amp main
fuse and verified during gauge
“power-up” and reset. In the event
of clock memory power failure
(blown fuse, etc.), the gauge will
“power-up,” reset, and shut down
repeatedly until clock memory
power is restored. Always check
this fuse if this gauge condition is
noted.
NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the engine
coolant temperature exceeds the normal
operating range, the temperature icon
will begin flashing and the LCD will go
blank for 30 seconds; then the LCD will
return to normal. However, the tem-
perature icon will continue to flash.
3. Mode Button - Shifts the gauge
through three set-up modes: speedome-
ter/tachometer, distance, and time.
NOTE: The Mode Button must be
pressed and released to shift
modes. Approximately two seconds
after the Mode Button is released,
the digital gauge will return to full
display.
4. Set/Reset Button - In conjunction
with the Mode Button, sets and resets
various displays on the digital gauge.
Also used to shift from speedometer
function to tachometer function on
the speedometer/tachometer gauge.
5. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
6. Low Oil Pressure - Will be displayed
during self-test at start-up. It will not
be displayed during normal operation
as oil pressure is not monitored on
these models.
7. Odometer/Trip Meter - Odometer reg-
isters the total distance the vehicle has
traveled. The trip meter is resetable
and can be used to measure trip or trip
legs. The odometer cannot be reset.
NOTE: To shift between the odom-
eter (ODO) or trip meter (TRIP),
press the Mode Button to select the
distance mode; then press the Set/
Reset Button to select the desired
display. Hold the Set/Reset Button
down to reset the trip meter.
8. Gear Position Indicator - Indicates
which gear position is selected.
• R (reverse)/N (neutral)/L (low range)/H
(high range)
Summary of Contents for ALTERRA 400
Page 75: ...73 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES...
Page 76: ...74 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES...
Page 77: ...75 NOTES...
Page 78: ...76 NOTES...
