44
Oil Level Stick
ATV-0100AA
KC0051A
There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
NOTE: The ATV should be on
level ground when checking the
engine oil level.
1. Remove the push pin and access
panel.
XR190
2. Unscrew the oil level stick and wipe
it with a clean cloth.
3. Install the oil level stick and thread it
into the engine case.
4. Remove the oil level stick; the
engine oil level should be above the
“L” mark but not higher than the “F”
mark.
Seat Latch
XR414
1. To remove the seat, lift up on the
latch release (located at the rear of
the seat); then raise the rear of the
seat and slide it rearward.
2. To lock the seat into position, slide
the front of the seat into the seat
retainers and push down firmly on
the rear of seat. The seat should
automatically lock into position.
Safety Flag Bracket
A bracket is provided for mounting a flag
at the rear of the ATV.
CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
above the “L” mark but not higher
than the “F” mark.
! WARNING
Make sure the seat is secure before
mounting the ATV. Serious injury
may result if the seat is not properly
secured.
Summary of Contents for ALTERRA 400
Page 75: ...73 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES...
Page 76: ...74 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES...
Page 77: ...75 NOTES...
Page 78: ...76 NOTES...
