! WARNING
Indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
20
Boots/Ankle Protection
Wear a boot that covers the largest possi-
ble area of your leg (preferably up to
your knee) and can handle significant
impact. Choosing boots with low heels
and a good tread will help prevent your
feet from slipping off the footrests in wet
or rugged conditions or getting hurt if
they get hit by rocks, dirt, or branches.
Eye Protection
Wear eye protection, such as goggles, to
completely surround your eyes to prevent
getting dirt or other items in your eyes.
Do not depend on sunglasses for proper
eye protection. Sunglasses are not recom-
mended; they don’t prevent objects from
flying in through the sides.
Long Pants and Long
Sleeved Shirt
The goal is to protect your body from
branches, long grass, airborne objects, or
anything else that could scrape your skin.
The more thick and durable the material,
the better protection it’ll provide. Riding
pants with kneepads, a jersey, and shoul-
der pads provide the best protection.
The second step in Prevention is check-
ing the condition of your ATV. Chances
are good that you’ll be using your ATV in
some rough terrain, and there’s no way
you want your brakes to go out when rid-
ing downhill. You need to complete the
Pre-Operating Inspection and check the
following parts on your ATV before
every ride.
1. Tires and Wheels
2. Controls and Cable
3. Lights and Electrical
4. Oil and Fuel
5. Chassis and Drive Train
6. Miscellaneous Items
1. Tires and Wheels
Correct tire pressure is crucial. Consult
the General Maintenance section of this
Operator’s Manual for tire pressure
guidelines. Incorrect tire pressure can
cause poor handling, instability, and a
loss of ATV control.
While checking the tire pressure, inspect
the tread and sidewalls of the tires for
cracks, cuts, or other damage that could
indicate they need to be replaced.
2. Controls and Cable
With the engine running and brake
applied, check all transmission posi-
tions: park, reverse, neutral, high, and
low.
A. Brakes
Squeeze your hand brake lever. If it feels
soft or “squishy,” it could be low on fluid
or have a leak — refer to the General Main-
tenance section of this Operator’s Manual
for instructions. Don’t use the ATV until
the brakes are operating normally.
Test the brake lever lock and see if it locks
the hand brake lever into position; then
disengage it to release the brake. Be sure
the rear foot brake near the footrest is
working; your brakes could fail during a
ride if they’re not maintained.
Pre-Operating
Inspection
Check:
1. Tire pressure
2. Tire surface (tread and sidewalls)
Check:
1. Park
2. Reverse
3. Neutral
4. High
5. Low
Check:
1. Hand brake lever
2. Rear foot brake
3. Brake lever lock
