10
2. Open the air bleed bolt located on
the oil pump (beneath the coolant
tank) to purge air from the oil hose.
ZJ004A
NOTE: When air can no longer be
heard purging from oil pump bleed,
tighten the bleed bolt to 7.5 ft-lb.
3. Start the engine. The warning icon
should go out within five seconds.
4. If the warning icon does not go out,
shut the engine off immediately and
repeat step 2; then repeat step 3.
If the warning icon does not go out or if
the engine does not start, take the snow-
mobile to an authorized Arctic Cat Snow-
mobile dealer. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.
Indicator Icons (Deluxe
Gauge)
Certain models are equipped with a
deluxe gauge combination speedometer/
tachometer. Indicator icons are incorpo-
rated within the speedometer/tachome-
ter. Also incorporated into the
speedometer/tachometer is a digital read-
out screen.
FZ001A
A. High Beam
B. Oil Pressure/Low Oil
C. Coolant Temperature
D. Increment Button
E. Select Button
F. Decrement Button
G. Service
H. Charging System (Bearcat Z1
XT LTD/TZ1)
RPM/MPH (kph)
By pushing the increment button once,
the RPM and MPH will be displayed
(one on the readout screen and one with
the needle). By pushing the button once
again, the functions will be reversed.
By pushing the increment button (with
speed being displayed) for more than two
seconds, the display will change between
standard mph or metric kph.
With RPM displayed on the readout
screen by pushing and holding the incre-
ment button, maximum RPM will be dis-
played on the readout screen. The
maximum RPM readout will reset when
the decrement button is pushed (while
maximum RPM is displayed).
Odometer/Trip-Meter (1)/
Trip-Meter (2)/Hour-Meter
By pushing the decrement button, the
readout screen will display odometer,
trip-meter (1), trip-meter (2), and hour-
meter. To reset the trip meter with the trip
meter displayed, push and hold the decre-
ment button until the display is cleared.
The hour-meter readout will not reset.
Clock/Altimeter
By pushing the select button, the readout
screen will display clock, altimeter, and
maximum altimeter.
To set the clock, select clock on the dis-
play by pushing and holding the select
button for two seconds; the option of
selecting the 12-hour or 24-hour clock
mode is available. Push the increment
button to toggle between the 12-hour dis-
play and the 24-hour display. When
desired mode is displayed, push the
select button.
CAUTION
Do not attempt to start the engine
with the bleed bolt open.
Summary of Contents for BEARCAT F5
Page 1: ...BEARCAT F5 F570 T SERIES...
Page 7: ...3 Snowmobile Safety Rules...
Page 69: ...65 NOTES...
Page 70: ...66 NOTES...
