GENERAL INFORMATION
11
When operating the snowmobile at
high altitudes, it may be necessary to
change certain component parts of
the drive clutch. See an authorized
Arctic Cat Snowmobile dealer for
further information.
DRIVE CLUTCH/DRIVEN
PULLEY ALIGNMENT
The parallelism and the offset
between the drive clutch and driven
pulley are set at the factory. Nor-
mally, no adjustment is necessary as
long as neither the drive clutch nor
the driven pulley is removed or dis-
assembled. However, if premature
drive belt wear is experienced or if
the drive belt turns over, the drive
clutch/driven pulley alignment must
be checked. Take the snowmobile to
an authorized Arctic Cat Snowmo-
bile dealer for this service.
FUEL PUMP
The fuel pump is designed to pro-
vide adequate amount of gas to the
carburetors at all throttle settings. If
a fuel delivery problem is suspected,
take the snowmobile to an autho-
rized Arctic Cat Snowmobile dealer.
SHOCK ABSORBERS
Each shock absorber should be visi-
bly checked weekly for excessive
fluid leakage, cracks or breaks in the
lower case, or a bent plunger. If any
one of these conditions is detected,
replacement is necessary. Take the
snowmobile to an authorized Arctic
Cat Snowmobile dealer for this ser-
vice.
NOTE: When the snowmobile is
o p e r a t e d i n e x t r e m e l y c o l d
weather (-23° C/ -10° F or colder),
a small amount of leakage may be
present. Unless the leakage is
excessive, replacement is not
necessary.
Also, it is required that rebuildable
gas shock absorbers be cleaned and
recharged after the initial 200 miles.
This service is considered normal
maintenance and is the responsibil-
ity of the owner. Take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
TRACK STUDS
0726-207
Studs must only be installed on the
center belt using the pattern illus-
trated. For proper installation, use
the following procedure:
1. Measure 38 mm (1 1/2 in.) in
from the edge of the center belt;
then drill the stud hole using the
proper-sized hole drill.
2. Push the stud through the hole
from inside the track; then place
the domed support plate and
lock nut on the exposed stud.
! CAUTION
DO NOT attempt to service the
drive clutch and driven pulley.
The drive clutch and driven pul-
l ey mu s t b e s e r v i c e d by a n
authorized Arctic Cat Snowmo-
bile dealer only.
! CAUTION
Do not use studs that are more
than 9.525 mm (0.375 in.) longer
than the track lug height. Also,
do not install studs in the outer
track belts.
Summary of Contents for Crossfire 700 EFI (EB) 2006
