Arctic Cat M 1100 Turbo Operator'S Manual Download

Page: 12 / 68

With RPM displayed on the readout

screen by pushing and holding the left

button, maximum RPM will be displayed

on the readout screen. The maximum

RPM readout will reset when the right

button is pushed (while maximum RPM

is displayed).

Odometer/Trip-Meter (1)/

Trip-Meter (2)/Hour-

Meter/Clock



NOTE: The clock is available on

electric start models only.

By pushing the right button, the readout

screen will display odometer, trip-meter

(1), trip-meter (2), hour-meter, and clock.

To reset the trip meter with the trip meter

displayed, push and hold the right button

until the display is cleared. The hour-

meter readout will not reset.

Clock (Electric Start)

With the clock selected on the readout

screen by pushing and holding the right

button for two seconds, the option of

selecting the 12-hour or 24-hour clock is

available. Push the left button for 12-hour

display; push the right button for 24-hour

display. At this point, the hours and min-

utes will begin to flash. Push the left but-

ton to change the hour display; push the

right button to change the minute display

(either tap the buttons for individual num-

ber display or push and hold the buttons

for rapid number display).



NOTE: During clock setting if nei-

ther button (left, right) is pushed
within a 5-second time period, the
clock-setting mode will be exited
with changes saved.

Service Icon

On electric start models, the icon should

illuminate each time the key is turned to

RUN or START, and it should go out when

the engine starts. If the icon stays illumi-

nated (on electric start models) or it illumi-

nates while the engine is running, the

system is receiving input that is outside of

its established parameters. If the icon illu-

minates indicating an error, take the snow-

mobile to an authorized Arctic Cat

Snowmobile dealer for service. If not under

warranty, this service is at the discretion

and expense of the snowmobile owner.

Coolant Temperature

Warning Icon



NOTE: On the 1100 cc models

when cold-starting the engine, the
coolant temperature warning icon will
illuminate, the readout screen will
display TEMP, and engine RPM limit
will be below drive system engage-
ment speed.

When the engine reaches proper operat-

ing temperature, the coolant temperature

warning icon and TEMP display will

cease to flash.
If the coolant temperature rises too far

above proper operating temperature, the

coolant temperature warning icon will

flash a warning (alert) and the engine will

“surge” to alert the operator. If the cool-

ant temperature rises to a critical point

above proper operating temperature, the

coolant temperature warning icon will

cease flashing and will remain constantly

illuminated.



NOTE: If the coolant temperature

icon is constantly on, the engine will
shut off if vehicle speed is reduced
to 1.5 kph (0.9 MPH) or slower.

Charging System Warning

Icon (1100 cc Models)

The Charging System Warning Icon is

designed to warn the operator if the bat-

tery charging system is not functioning.

The icon should illuminate each time the

key is turned to RUN or START, and it

should go out when the engine starts. If

the icon stays illuminated or it illuminates

while the engine is running, the battery is

not being charged, and the snowmobile is

running on battery reserve power only.

CAUTION

At this point, take precautionary mea-
sures such as changing to loose
snow terrain, shutting the engine off
(allowing the engine to cool down),
and checking coolant level. If unable
to either determine or remedy the
problem, take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for service. If not under war-
ranty, this service is at the discretion
and expense of the snowmobile
owner.