2-10
CD629B
6. Start and warm up the engine.
7. Shut the engine off and allow to stand for 2-3
minutes.
8. Remove the oil level stick and wipe with a clean
cloth.
9. Insert the oil level stick until the threads touch
the engine.
NOTE: The oil level stick should not be threaded
into the engine for checking the oil.
10. Remove the oil level stick; the engine oil level
should be above the illustrated “L” mark but not
any higher than the illustrated “F” mark.
ATV-0100
11. Inspect the area around the drain plug and oil
screen/filter cap for leaks.
Tires
TIRE SIZE
The ATV is equipped with low-pressure tubeless
tires of the size and type listed (see Section 1). Do
not under any circumstances substitute tires of a dif-
ferent type or size.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.21
kg-cm
2
(3.0 psi).
Steering Components
The following steering components should be
inspected periodically to ensure safe and proper
operation.
A. Handlebar grips worn, broken, or loose.
B. Handlebar bent, cracked, and an equal and
complete full-left and full-right turn capabil-
ity.
C. Steering post bearing assembly/bearing hous-
ing broken, worn, or binding.
D. Ball joints worn, cracked, or damaged.
E. Tie rods bent or cracked.
F. Knuckles worn, cracked, or damaged.
G. Cotter pins damaged or missing.
Drive Chain/Sprockets
CHECKING DRIVE
CHAIN/SPROCKETS
The following drive system components should be
inspected periodically to ensure proper operation.
A. Chain (excessive stretch or slack).
! CAUTION
Do not over-fill the engine with oil. Always make
sure that the oil level is above the “L” mark but no
higher than the “F” mark.
! WARNING
Always use the size and type of tires specified.
Always maintain proper tire inflation pressure.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
