4-7
4
CD589
6. Install the float chamber drain hose and the vent
hose to the carburetor.
7. Install the gas hose onto the carburetor.
CD588
Throttle Cable Free-Play
To check/adjust throttle cable free-play, see Section
2.
Engine RPM
(Idle)
To adjust the idle RPM, see Section 2.
Gas Tank
REMOVING
1. Turn the fuel valve to the OFF position.
2. Remove the gas hose from the carburetor by
removing the spring clamp; then funnel the gas
hose into an appropriate container of sufficient
size to catch all the gas from the gas tank.
3. Turn the fuel valve to the RES position and
drain the gas from the gas tank.
4. Remove the seat.
MD2415
5. Remove the top handlebar clamps.
MD2139
6. Carefully lay the handlebar assembly forward
on the front fender panel.
NOTE: To access the gas tank, it is necessary to
move the front fender panel, which requires
removing the handlebar from its clamp. However,
the levers, controls, cables, and wires do not need
to be disconnected. The front fender panel and
handlebar assembly can be tilted forward far
enough to gain access to the gas tank.
7. Remove the four Phillips-head cap screws and
six nuts securing the front fender panel. Account
for eight washers.
8. Remove the gas tank cap; then tilt the front
fender panel and handlebar forward.
! WARNING
Whenever any maintenance or inspection is made
on the fuel system during which there may be fuel
leakage, there should be no welding, smoking, open
flames, etc., in the area.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
