27
27
Start-up:
1. Add pucks to floating dispenser and open to setting 4.
2. Add 7 tablespoons (100 grams) of Arctic Pure
®
Refresh per 1500 litres (396 gallons) of water.
3. Add 1 tablespoon (14 grams) of Arctic Pure
®
Boost per 1000 litres (265 gallons) of water.
4. Test the Chlorine level. Once the chlorine reads within the ideal range (1-3 ppm) turn tablet
dispenser down to 1 - 2 (more or less according to bather load).
5. Start the Boost Filtration mode to circulate the chemicals and do not use spa for two hours after
the mode ends.
Note:
The above example is for a spa without an ozone system. If your spa is equipped with an
ozone system please contact your dealer for proper Chlorine levels.
Weekly:
1. Add pucks to floating dispenser and reset the setting if necessary.
2. Add 7 tablespoons (100 grams) of Arctic Pure
®
Refresh per 1500 litres (396 gallons) of water.
3. Wait at least one hour and add 1 tablespoon (14 grams) of Arctic Pure
®
Best Defence per 1000
litres (265 gallons) of water.
Important:
Arctic Pure
®
Refresh significantly reduces pH and TA. One hour after adding Arctic
Pure
®
Refresh test and adjust TA and pH as needed.
Bromine Tablet System:
Note: If you are planning to use your new spa right away, Peak Boost must be added first. Follow direc-
tions for adding Peak Boost from this page.
1. Fill floating dispenser with pucks and open to setting 7.
2. Add 7 tablespoons (100 grams) of Arctic Pure
®
Refresh per 1000 litres (396 gallons) of water.
3. Add 2 1/2 tablespoons (35 grams) of Arctic Pure
®
Peak Boost per 1000 litres (265 gallons) of
water, to establish a Bromide reserve.
4. Test the Bromine level. Once bromine reads within the ideal range (3-5 ppm) turn tablet
dispenser down to 2 or 3 (more or less according to bather load).
Note:
The above example is for a spa without an ozone system. If your spa is equipped with an ozone
system please contact your dealer for proper Bromine levels.
Weekly
1. Twice a week test and adjust Total Alkalinity, pH and Chlorine or Bromine levels.
In extreme cases of source water with high minerals (such as some well water), add
1 tablespoon (14 grams) per 1000 litres (265 gallons) of Arctic Pure
®
Best Defence weekly.
Important:
Arctic Pure
®
Refresh significantly reduces pH and TA. One hour after adding Arctic
Pure
®
Refresh test and adjust TA and pH as needed.
The use of Clarifiers and Foam inhibitors is not recommended with Arctic Pure
®
Disposable filters!
IMPORTANT:
Chemical doses given in this manual are for reference ONLY. ALWAYS refer to
product label for instructions.
