ARCTIC WIND AP6018, User Manual

Auto Mode

1)

Install the exhaust hose and window kit properly (see pages 

3

&

4

).

2)

Plug the Power Cord into an electrical outlet.

3)

Turn on the unit by pressing the 

POWER 

button.

4)

Press the 

MODE 

button until the 

AUTO

 mode indicator

lights up on the control panel display. 

Bucket Full Indicator

When the Internal Water Tank is full, the Bucket Full light will illuminate and the unit will automatically 
shut down. The air conditioner will resume normal operation once Internal Water Tank is emptied.

Internal Water Tank

When the room temperature is low and the indoor humidity is high, the air conditioner may not be able to 
evaporate some of the moisture fast enough. When this happens, the water will accumulate in an internal 
water tank inside the unit. The internal water tank holds approximately 1.5 liters of water. When this tanks 
becomes full, the unit will automatically shutdown and illuminate the Bucket Full indicator.

Fan Mode

1)

Plug the Power Cord into an electrical outlet.

2)

Turn on the unit by pressing the 

POWER 

button on the control panel.

3)

Press the 

MODE 

button until the 

FAN

 mode indicator lights up on the control panel display.

4)

Select the fan speed by pressing the 

FAN SPEED 

button. 

NOTE: 

It is not necessary for the exhaust hose and window kit to be installed to operate the unit in 

fan mode. 

Auto Mode will operate the unit in 

Cool

 mode when the temperature is above 72 degrees, Fan mode 

when the temperature is below 72 degrees.  

Sleep Mode

1)

Install the exhaust hose and window kit properly (see pages 

3

&

4

).

2)

Plug the Power Cord into an electrical outlet.

3)

Turn on the unit by pressing the 

POWER 

button on the control panel.

4)

Press the 

MODE 

button until the 

SLEEP

 mode indicator lights up on the control panel display. 

NOTE: 

When in 

SLEEP 

mode, the fan will run on low to keep fan noise at a minimum. The temperature 

setting will gradually increase to 2°F above the original set temperature each of first 2 hours. The unit will 
keep operating the same temperature until the sleep mode is turned off. 

10

UNIT OPERATION