Galvanized Gas Spreader
Page 7
Selection Of Lubricant
Our gearboxes are normally filled up with oil of S.A.E. grade 80W90. Where a wide temperature
range is expected, the synthetic oil MOBIL SHC 634 is recommended. Synthetic lubricants
permit extended life time between drains. This is due to the increased resistance to thermal
degradation or oxidation.
Conveyor Chain Lubrication
When you receive your new spreader, it is not necessary to lubricate the chain. However, when
you store the machine at the end of the season, it is crucial to lubricate it properly to prevent
chain links from seizing. One way is to remove the chain and store it in a lubricant.
Electric System
When you install the spreader, it is very important to put dielectric grease in every connection.
Also, during the season, make sure to inspect the connectors regularly and add dielectric grease
when needed. Also, when the season is over, all connections need to be well cleaned and
lubricated with dielectric grease to prevent corrosion and rust during the storage period.
Before Operating
1)
Engine oil and speed reducer oil level.
2)
Grease all lubrication points.
3)
Ensure all belts are tight.
4)
Ensure that the conveyor chain is dragging for one foot on the bottom return channel, of `
the spreader. (Do not over tighten the chain).
5)
Ratchet straps are in good condition, and all bolts are tight.
Maintenance Inspection
Daily Inspection and Lubrication
a)
Check gearbox oil level. It should be filled to the oil filler plug (Picture #1).
b)
Check engine oil level with dipstick (also check gas).
c)
Lubricate the following grease nipples:
1)
One on each conveyor idler shaft bearing (Picture #8, Item #27 on Parts List)
2)
One on the drive shaft bearing (Picture # 7, Item #19 on Parts List)
3)
One on each (2) spinner shaft bearing (Picture #11, Item #12 on Parts List)
