Arctiko BBR 950, Operating Instructions Manual

Installation

Before use

Installation

1.

Unpacking

Remove all the packing materials, and open the door of the appliance to ventilate. Mild detergent
solution can be used to clean the appliance external surfaces.

2.

Leveling

Turn the adjustable bolt anticlockwise to level the appliance.

3.

Fixing the shelf fence

Take out the shelf fence and fix it on the rear wall of the compartment with M5 screws.

4.

Preparation for the temperature sensor test bottle 

Before using your appliance, ensure that the test bottle in the drawer is filled with solution to the
scale 200. If not, follow the instructions listed hereunder to fill the test bottle (including upper and
lower test bottle) with 10% glycerin (or other solution such as glycol).

1. Remove the upper and bottom drawers and then sensor fixing panel.
2. Dismount the sensor from the test bottle.
3. Remove the two screws for dismounting the test bottle.
4. Fill the test bottle with 10% glycerin (or other solution such as glycol) to the scale 200.
5. Replace the capped test bottle in its original position.
6. Set the sensor on the test bottle and replace the sensor fixing panel.

Operation Instructions

Temperature adjusting:
Press and hold both SENSOR SELECT button and CALIB CANCEL button for more than 3s until original 
setting starts flashing to indicate that it enters temperature setting mode. With each press os CALIB 
CANCEL button, temperature setting increases 0.1°C until reaching upper limit, which is defaulted as 
8°C. If press again, it returns to lower limit, which is defaulted as 2°C. It repeats the above cycle. When 
it reaches your desired temperature, if you don't press the button within 5s, the temperature setting will 
be saved and it automatically quits the temperature setting mode (the temperature setting range 
programmed  at factory is 2-8°C). The display returns to display inside sensor temperature or average 
temperature before setting is made (not flashing).

9