Access Multiplexer with Fast Ethernet
User Manual
51
monitoring PCs;
setdevip –M[I] To modify the IP address of nine
monitoring PCs, the parameter I can be applied to modify a single
address.
Note: The IP address shall ensure the location in the same network
segment as the computer.
setpswd
：
Modify the startup password. The effective length shall
be less than 12 bytes.
setbaud
：
Query and modify the transmission speed.
Query: Simply input setbaud;
Modfiy: When the baud rate set at 19200, input
setbaud 1;When the baud rate set at 9600, input setbaud 0
setmask
：
Query/modify the subnet mask of the agent. Normally it is used
to set the mask.
Query: Simple input setmask
Modify: input setmask
＊
.
＊
.
＊
.
＊
To change to 255.255.255.0, simply input setmask
255.255.255.0
setgate
：
Query and modify the gateway address of the agent. In the case of
trans-segment, the command is used to set gateway.
Query: Simple input setgate
Modify: input setgate
＊
.
＊
.
＊
.
＊
To change to 192.168.0.1, simply input setgate 192.168.0.1
setname:
Set a name of a byte amount no more than 20, to facilitate the
identification of the agent in the management.
s
etkey:
The command can set the agent key, which provides a base for the
agent to manage a certain number of equipment. The agent can not work in order
without a proper key.
Special note: All the above-mentioned commands are presented as small
letters.
Summary of Contents for AMX32FE
Page 1: ...AMX32 ...
Page 58: ...Access Multiplexer with Fast Ethernet User Manual 57 ...
