EN
13
1. SAFETY REQUIREMENTS
Before connecting the convector to the power supply
network, be sure to visually check the power cord
and the convector for mechanical damage. If there
are damages, contact an authorized service center for
repair. Before rapairing damage, it is not allowed to
connect the convector to the power supply network.
Disconnect the convector from the power supply
network during its maintenance, wet cleaning of
the room near the convector installed on the floor.
Disconnect the electric convector from the power
supply network by holding the plug of the power cord.
Do not allow moisture inside the convector with the
usual design of the shell. Convectors with splash-proof
design of the shell should be installed so that the
controls are not accessible to persons taking a bath,
being in the shower or in the pool.
Do not allow paper or foreign objects inside the
convector.
Do not use the convector for other purposes (the
convector is not intended for outdoor use).
Do not operate the convector with damaged power cord.
Make sure that the power cord does not not touch sharp
corners and heated surfaces of the convector.
WARNING!
If the power cord is damaged, it should be
replaced by the manufacturer, an authorized service
center or similar qualified personnel in order to avoid
danger. This device can be used by children over 8
years of age and persons with physical or sensory or
mental disabilities or with insufficient experience and
knowledge, if they are under constant supervision