EN
15
WARNING! Before installing and operating this
product, please read this “User Manual” (hereinafter
referred to as “the manual”) carefully.
Due to the continuous improvement of the product,
there can be made changes in the design of the product
that are not reflected in this manual without reducing its
consumer properties.
2. GENERAL INSTRUCTIONS
This manual applies to the wall electric convectors,
29.7-14307771-009:2006 technical standards of Ukraine
(hereinafter referred to as “convectors”).
Convectors are designed for primary and secondary
heating of buildings in domestic and similar conditions.
Convectors are installed permanently on the wall or on
the floor on passive supports.
Convectors are equipped with a thermostat to set
and maintain the desired temperature in the room,
protection against overheating, as well as the function
of protecting the room from freezing (maintaining
the room temperature (5...7) °C, which does
not allow freezing of the room with minimal energy
consumption).
Convectors are designed for round-the-clock operation
without supervision.
When buying a convector, require a check of its
operability, compliance of the delivery set with the
“Package contents” section of this manual, and the
absence of mechanical damage. Check the availability
of warranty card, completeness and correctness of its
filling. The convector model should comply with the
data indicated in the warranty card. The warranty card is
valid only if there is correctly and legibly specified sales
data, clear seals of the seller.
