EN
14
BEFORE THE FIRST USE
After device transportation or storage at low temperature keep it for at least three
hours at room temperature.
•
Unpack the device.
•
Check the device for damages, do not use it in case of damages.
•
Make sure that the device operating voltage corresponds to the voltage of
your mains.
•
Make sure that the operation mode switch (4) is set to the position «0» (the
device is switched off).
SETTING
•
Turn the device over.
•
Install the legs on the convector body, making sure that they are correctly
located at the lower ends of theheater’s side moldings.
•
Attach the legs to the base of the heater with 4 self-tapping screws (2 for
each leg) as shown in the picture:
•
Turn the device over and place it on its legs.
USING THE CONVECTOR
•
Before switching the device on, make sure that your home mains voltage
corresponds to the device operating voltage, and the operation mode switch
(4) is in the position «0» (the device is switched off).
•
Insert the power plug into the outlet.
•
Turn the thermostat knob (5) fully in a clockwise direction to the maximum
setting.
Summary of Contents for CHH-2000MBR
Page 24: ......
