13
EN
Before use for the first time
Before first use, remove possible manufacturing process residues by
boiling 3 full kettles of water. Dispose this water.
Tip:
You can use vinegar or special descaling agents for the first time.
Use
1. Turn the jug so that the spout faces away from you.
2. Pull up the lid handle (3).
3. Fill the jug with the required quantity of water (at least 0,5 liter and
a maximum of 1,8 liters). Never fill the water boiler over the “Max”.
Otherwise the hot water can spatter out of the base.
ATTENTION!
Make sure that you do not spill any
water on the base.
4. Pull up the lid handle to open the lid.
5. Place the jug on the base, and insert the plug in the wall
socket. Push down the on/off switch. The on/off pilot light will
illuminate.
6. The jug kettle is now switched on, and the water will now begin
to heat. The jug kettle switches off automatically a few seconds
after the water has come to the boil. The on/off pilot light will
now extinguish.
7. Remove the jug from the base by the handle, and pour the water out.
ATTENTION!
Be carefully you do not contact the hot
water. It can cause serious burning wounds.
8. When you wish to heat the water without it coming to the boil
you can switch off the jug kettle at any time you require.
9. Remove the plug from the wall socket when you have finished
using the jug kettle.
Overheating safeguard
The jug kettle is fitted with an overheating safeguard. This will
switch off the jug kettle if it is operated without (sufficient) water.
Allow the jug kettle to cool down for at least 10 minutes before
using it again.
