EN
Heating area 18m²-21m²
Mediumwave Infrared heat is characterised by a strong central beam that dissi-
pates to a gentler intensity heated area outside the central beam.
The zone heated by heater will increase in size the higher the heater is installed
from the floor, but the warmth experienced from the heater will be lower.
The mounting height and intensity should reflect the intended use of the heater.
Mount the heater at a lower height in areas intended for low physical activity (for
example a seating area) or areas subject to stronger airflow (outside or near open
doors).
Mount heater higher where less intense warmth is needed (for example ware-
houses where workers are active or wear warm clothing).
For permanent installation (i.e. not using a stand), the heater must be located in a
position to allow proper and efficient use but one that ensures hot parts are not
touched accidentally.
The recommended installation height of the heater is 2.4m to 3.5m (95”-138”)
from the floor.
IMPORTANT:
DO not mount heater below 2.4m if any kind of automated on/off
controller is to be used
Under no circumstances is the heater to be installed at less than 1.8m (71”) from
the floor. Consideration should be given to any temporary or occasional additions
such as stages or platforms and adjusted accordingly. For outdoor use, or other
areas with air movement/wind the directional Infrared spread may reduce by 1/3
to 1/2.
Wall/ceiling mount swivel brackets are provided with the heater which has been
specifically designed to allow this product to be fitted to a wall or ceiling with ad-
equate clearances at the back of the unit. Do not mount the heater with any other
bracket except those provided.
The sides and ends of the heater must always be at least 500mm (19.6”) away
from the nearest wall, ceiling or other structure.
