en
9
Using the Power Pumping function—step-by-step procedure
Expressing
Switch the breastpump on and press the Power Pumping button.
First expressing phase
The first segment of the button starts to light up green and the breastpump starts in stimulation mode. You
can adjust the vacuum and the cycle to what is comfortable for you. After two minutes, Ardo Bellis switches
to the expression mode. Again, you can select the vacuum and cycle that work for you. The color of the
mode button
tells you which mode the breastpump is in.
First pause
After 20 minutes a tone sounds and the first 10 minute pause starts. The second segment of the button
lights up white. At the end of the pause, a reminder signal sounds.
You then have 5 minutes to press the Power Pumping button and continue expressing (during this time, the
segments flash and a regular beep sounds). Otherwise, the breastpump switches off.
Second expressing phase
Ardo Bellis expresses for 10 minutes. The settings for vacuum and cycle from the first expressing phase are
used automatically. However, you can adjust these values at any time to suit your needs.
Second pause
After 10 minutes a tone sounds and the second pause starts (see first pause for the sequence).
Third expressing phase
The settings for vacuum and cycle from the second expressing phase are used. However, you can adjust
these values at any time to suit your needs. After 10 minutes the Power Pumping stops and Ardo Bellis
switches off automatically.
The time indicator counts down the specified time in each phase.
Summary of Contents for bellis
Page 3: ...F G C H D I E L K A B M J Ardo Bellis H ...
Page 99: ......
Page 100: ......
Page 101: ......
