User’s Manual
–
A
REBO
S Floor pool cleaner
4
stones, etc. and to clean the corners / edges of the pool.
- Use the Vacuum Cleaner Brush to suck in fine and/or small deposits, such as Dirt and dead algae
on the pool floor.
Note
: Make sure that the edge on the top of the dirt container matches the groove on the vacuum
cleaner.
4. Attach one end of the suction hose to the bottom of the dirt container. Make sure that the end of
the hose covers the seal on the base.
5. Press the plastic clip and connect the telescopic rod to the dirt container lower part. Align the
plastic clip so that it twists into the shaft with the holes and the spring jumps into the pre-drilled
holes. Adjust the length of the handle by unlocking, extending and locking the individual areas
accordingly.
6. Screw the adapter from the inside of the pool to the screw connection.
7. You can now pour the assembled product into the water.
8. Fill the hose with water by slowly immersing it in the water to remove the trapped air from the
hose.
Tip: Start at the end of the hose closest to the dirt container bottom and slowly dip the hose
vertically into the water, section by section
.
9. When the hose is full of water, the water will flow out of the other end.
10.Quickly connect the other end of the hose to the adapter.
11.Turn on the pump. To remove trapped air from the hose and pump, turn the vent valve once or
twice to open the valve if necessary. For details, please refer to the pump manual.
Important
: Never let the pump run dry. This will cause the filter pump to overheat and may cause
damage. Keep the pool vacuum cleaner constantly under water during use, otherwise air will enter
the hose. This will cause the pump to run dry and may damage it.
12. when the dirt bag is full and the vacuum cleaner only sucks slightly, switch off the pump and
remove the vacuum cleaner from the water. Empty the dirt bag by reversing steps 1 to 3. Check that
the dirt bag and the pool cleaner housing are clean before reusing them. Repeat steps 1 to 3 to
reassemble the components.
Note
: If you find that the vacuum cleaner is weakly vacuuming but the dirt bag is clean, make sure
that the pump is running, that there is no blockage and/or that air is trapped in the water circuit.
4. Operation
4.1 Before use
•
Vent the hoses and pump before use.
•
Always keep the lower part of the dirt container under water during use.
•
Remove the dirt container base, hose and adapter and insert the filter strainer when only the
filter pump is running and the pool is not in use.
•
Check and empty the dirt bag during and after each use.
4.2 Operation of the pool vacuum pool cleaner
1. The filter pump is an airtight system. To remove trapped air from the hose and pump, turn the
vent valve counterclockwise once or twice to open the valve.
2. As soon as you notice that water is coming out of the air outlet valve, close the air outlet valve
again, but not too tightly.
