User’s Manual
–
A
REBO
S Floor pool cleaner
5
3. Connect the pump to the mains and switch on the pump.
4. Now you can drive slowly with quiet movements over the pool floor until the pool foil is free of all
impurities.
Important
: If the vacuum pool cleaner is weak, check whether there is still air in the hose. If the
vacuum pool cleaner still sucks too weakly, please read the operating instructions of your pump
again under chapter "Filter pump does not carry any water or the flow rate is very low". Also check
whether the dirt bag and the filter cartridge are clean.
5. Make sure that the filter pump is switched off and disconnect the mains plug from the socket.
Remove the vacuum cleaner from the pool.
6. Disassemble the pool vacuum cleaner by reversing the assembly instructions. Clean the dirt bag if
necessary.
7. Keep the vacuum cleaner in a safe place.
4.3 Assembling and operating the landing net
1. The landing net requires the same grip as the pool vacuum cleaner.
2. The landing net is equipped with a plastic clip, which is inserted in the end of the handle. Align the
clip to fit the holes drilled in the rod. Gently press the tips of the clip together so that the bar slides
into the landing net and the clip jumps into the pre-drilled holes.
3. Lightly brush the skimmer over the pool surface to remove leaves and other dirt.
4.4 Brush assembly and operation
1. The hand brush needs the same handle as the pool vacuum cleaner.
2. The brush head has a plastic clip at the end of the handle. Align the clip to fit the holes drilled in
the rod. Gently press the tips of the clip together so that the bar slides into the landing net and the
clip jumps into the pre-drilled holes.
3. Clean the sides and bottom of the pool film until it is free of deposits and dirt.
5. Storage
•
Make sure that the pump is switched off and unplug the cable.
•
Disassemble the pool vacuum cleaner, hand net or hand brush by reversing the assembly
instructions.
•
Clean all accessories thoroughly and allow them to dry thoroughly in the air.
•
The original packaging can be used as a storage container. Store the product in a cool, dry
place.
