User’s Manual –
A
REBO
S Floor fan
12
•
Observe the following notes
after
each transport:
-
Place the unit upright after each transport.
7.2 Storage
•
Observe the following notes
before
each storage:
•
Observe the following storage conditions when not using the device:
-
dry and protected from frost and heat.
-
in an upright position where it is protected from dust and direct sunlight.
-
with a cover to protect it from invasive dust if necessary.
-
Place no further devices or objects on top of the device to prevent it from being
damaged.
-
always keep out of the reach of children.
8.
Cleaning and maintenance
•
No part of the fan should be submerged in water or other liquids: If this happens, do not
immerse your hand in the liquid, but first disconnect the power plug from the mains socket.
Dry the device carefully and make sure all electrical parts are dry: If in doubt, consult a
specialist.
•
It is essential to keep the ventilation holes of the motor free from dust and other
contaminants.
•
Be careful not to create excessive dust deposits on the air inlet and outlet safety guard and
occasionally clean with a dry brush or a vacuum cleaner.
8.1 Activities before maintenance
•
Warning of electrical voltage!
Do not touch the power plug with wet or damp hands.
•
Turn off the device.
•
Disconnect the power cord from the wall outlet by grasping the power plug.
8.2 Clean the housing
•
Clean the housing with a damp, soft, lint-free cloth. Make sure that no moisture penetrates
into the housing. Make sure that no moisture can come into contact with electrical
components. Do not use aggressive cleaning agents, such as cleaning sprays, solvents,
alcoholic cleaners or scourers to moisten the cloth.
8.3 Remove safety guard
•
To clean the fan blades in accordance with this chapter, remove the safety guard as
described below. The device
AR-HE-BV20120S
has no mounting bracket, here it is sufficient
to solve only the connecting screw (6).
•
The device is switched off
•
The power cord is unplugged from the wall outlet.
-
Open the four fixing clips on the safety guard.