User’s Manual
–
A
REBO
S Auto Vacuum Drywall Sander
10
ASSEMBLE FOR LONGER HANDLE
•
According to the needs of different grinding position, can be the length of the machine to
adjust between 1100-1800mm. The locking nut counter-clockwise to loosen, the pipe is
pulled to the right length, and then clockwise rotating locking.
SANDING DRYWALL
•
The Drywall Sander has a unique articulating sanding head: the head can swivel in multiple
directions, allowing the abrasive pad to conform to the work surface. This enables the
operator to sand the top, middle and bottom of a wall or ceiling joint without changing: his
position.
1.
Connect the long-neck sander either with a dust bag or with your usual vacuum cleaner. To
do this, remove the vacuum cleaner hose and screw in the hose of the long-necked grinder
into the appropriate recess of the vacuum cleaner. Switch on the vacuum cleaner and long-
neck sander.
To install the dust bag, please refer to page 9 of this manual. Do not switch on the long-neck
grinder until you have connected a dust bag or vacuum cleaner.
CAUTION:
Wear a respirator approved for "Dust and Mist".
2.
Position Drywall Sander lightly against work surface (apply just enough pressure to align the
sanding head with the work surface).
3.
Apply additional pressure to engage the abrasive pad to the work surface: while moving the
Sander in an overlapping pattern to smooth the drywall compound down to a "featheredge'.
Apply ONLY enough pressure to keep the abrasive pad flat against the work. Excessive
