User’s Manual
–
A
REBO
S Auto Vacuum Drywall Sander
9
HOW TO HOLD A DRYWALL SANDER
•
The Drywall Sander should be held with both hands on the main tube as shown in picture.
The hands may be positioned anywhere along the main tube to provide the best combination
of reach and leverage for the particular application.
CAUNTION:
Keep hands on Main Tube. Do not place hand into area around the sanding
head. The sanding heads swivels in multiple directions and could pinch hand.
To Connecte with the dust collecting bag
•
In order to protect the operator to reduce dust suction and site cleaning process at work, in
the work process please connect the machine with dust bag. As shown in the figure is
connected with the dust collecting bag.
CAUTION:
Failure to use a dust bag rated for drywall dust will increase the level of airborne
dust particles in the work area. Continued and prolonged exposure to high concentrations of
airborne dust may affect the respiratory system function.
TO START AND STOP DRYWALL SANDER
•
Make sure power circuit voltage is the same as shown on the specification plate on the
Sander, and that the Sander switch is OFF. Connect Sander to power circuit.
The Drywall Sander is equipped with a “rocker” type switch. The lop end of the switch button
is labeled OFF, and the bottom end et the button is labeled ON. To start the Sander: depress
the bottom (ON) end of the switch button, to stop the Sander depress the top (OFF) end of
the switch button.
Sanding wheel speed regulation
•
The Drywall Sander is equipped with a variable speed control. The speed is adjusted by
turning the control knob. The control knob is numbered "min" through "max" with "min"
being the slowest speed (approximately 1000 RPM) and "max" being the fastest speed
(approximately 1850RPM).
Use the higher speed settings for fast stock removal. Use the lower speed selling to reduce
removal rate for more precise control.
