User’s Manual
–
A
REBO
S Drywall Sander
11
LARGE BRUSH
•
A large brush surrounds the abrasive pad. It serves two purposes: (1) It extends below the
surface of the abrasive pad so that it is in contact with the work surface first. This positions
the sanding head parallel to the work surface before the abrasive comes into contact with
the working surface, preventing the abrasive from causing scratches. (2) It also helps contain
the drywall dust until the vacuum cleaner pulls it away.
•
CAUTION: DISCONNECT SANDER FROM POWER CIRCUIT.
•
To replace it: (1) Remove abrasive pad (see ABRASIVE PAD REPLACEMENT). (2) Use a Phillips
screwdriver to remove the six retaining screws (3) Then remove the brush. (4) Place the new
brush in the housing and install it using the six retaining screws. (5) Replace the abrasive pad.
Cleaning and Maintenance
•
Tools should always be clean, clean up debris and dust.
•
Always change the oil (gearbox, bearings) for proper operation.
•
Always check the power cord, plugs, switches to make sure the tools are faultless.
•
The power tools manufactured by the company undergo a strict quality inspection. If the
machine is faulty, please consult the authorized service centre (SWAP) for repair.
Carbon brushes replacement
•
The accessories include an original set of carbon brush, when the carbon brush reaches its
wear limit, replace with a new one. Use a "+" screwdriver counter-clockwise to unscrew the
brush cover, remove the original carbon brush, place a new carbon brush and screw the
brush cover.
1.
MISE EN REBUT
