Original User Manual
–
A
REBO
S SPA Pool
19
-
Start water treatment immediately after filling the pool. The power supply has to be
ensured from this moment on, so that filtration can be started immediately.
-
Check the following water parameters and adjust them as follows:
pH value: 7.2
–
7.8
Free chlorine 3
–
5 ppm
Total alkalinity: 80
–
120 mg/l
•
The stated values must be regularly checked, at least twice a week, and before each time the
pool is used.
•
Use a good and clearly legible testing set for these tests.
•
Use water treatment products to correct and adjust the values.
•
If the pool is being used regularly, the water must be completely changed at least every two
months.
If the pool is used more intensively, the water must be changed more frequently.
•
Caution!
If the pH and chlorine content are not corrected, this can have a negative
impact on the life of the components.
•
Caution!
Never use fragrances. These oil-based agents can cause deposits and leaks.
5.4 Water treatment products
•
Always add the water treatment to the middle of the pool. The air jets and heater must be
switched on to achieve an optimum treatment effect. The use of water treatment products
in cold water has almost no effect. Keep the water treatment products in a cool, dry place
inaccessible to children.
•
For the disinfection of the SPA water there are different methods to choose from. Always use
a dosing float for dosing during SPA water care
–
this way you avoid the risk of bleach spots
or hole formations on the SPA surface.
•
Important:
Always remove the dosing float when using the SPA.
•
Test strips
Test strips are available which can be used to measure the pH value, chlorine content and
alkalinity.
•
Chlorine granules / tablets
Increase the chlorine content. After using chlorine granules or tablets, you must wait at least
7 hours before you can retest the water.
The full effects of the treatment can only be determined after this waiting period.
•
pH plus granules
Increases the pH value.
•
pH minus granules
Decreases the pH value.
5.5 Cleaning the pool
•
The cleaning of the SPA does not require any special care or maintenance. Remove dirt with
soap. water, a damp cloth and a soft brush, if required. Never use hard brushes or abrasive
cleaning and scouring products.
5.6 Repairs
•
If the wall of the pool has small holes or punctures these can be securely and invisibly
repaired with the repair patches supplied with the pool.
-
Thoroughly clean and dry the area to be repaired.
-
Spread the adhesive evenly over the back of the repair patch and press the patch
over the damaged area.
-
Smooth the surface to remove any air bubbles.
