Arecont Vision MegaDome
®
2 Installation Manual
Page | 17 support@arecontvision.com
Flush Mount Adapter (MD-FMA) Installation Instructions
(Sold Separately)
Inside the box:
A. white trim ring
B. Flush mount adapter
C. Mounting template
D. Pack of four (4) machine screws (#8-
32 ½”) and one (1) eyelet
Not included but needed:
E. #2 Phillips head screwdriver
Image 26
1. Remove the flush mount adapter, trim
ring and hardware from the box
2. Attach the dome to the flush mount
adapter as shown in Image 27. Please
reference “Mounting the Camera,” if
needed.
3. Using the mounting template, cut a hole
in surface for mounting.
4. Insert the flush mount adapter into the
hole.
5. Tighten the
“lever screws” until the flush
mount adapter is snuggly installed, as
shown in Image 27. The “Support Arm”
will ride down the screw to compress the
mounting surface. NOTE: Do not over-
torque the lever screws.
6. Attach the trim ring to the flush mount
adapter by rotating clockwise as show in
Image 28.
Image 27
Image 28
B
C
A
D
Lever
Screw
Support
Arm
