Corner Mount Adapter (MD-CRMA) Installation Instructions
(Sold Separately)
Inside the box:
A. Corner Mount Adapter
B. 2x Compression Fittings
C. Pack of four (4) machine screws (#8-32
5/8
”)
D. 2x Packs of four (4) screws and four (4)
anchors
Not included but needed:
SV-EBA (Electrical box adapter)
Image 34
1. Remove Corner Mount Adapter and
hardware from the box.
2. Install compression fittings to corner
mount adapter as shown in Image 35.
3. Attach wall mount adapter to corner
mount adapter and attach the wall
mount cap as shown in Image 36.
Image 35
Image 36
4.
Run the Ethernet cable and outside power
cable (if necessary) through the
compression fittings and MegaDome® Wall
Mount, MD-WMT2.
5. Using the screws provided (or other
hardware) attach the Corner Mount
Adapter to an exterior 90° corner wall.
6. Attach the dome to the wall Mount
Adapter.
Please reference “Mounting the
Camera,” if needed.
7. Tighten the compression fittings to seal the
wiring holes.
A
B
C
D
Wall
Mount
Adapter
p
MD-WMT2
