Arecont Vision MegaDome
®
2 Installation Manual
15 |
P a g e
Heater Kit MD2-HK Installation Instructions
(Accessory Sold Separately, except –H Models)
Note: Heater kit MD2-HK is not available on
MegaDome
®
2 WDR models!
A. Heater
Inside the box:
B. Two (2) plastic stand-offs
C. Two (2) screws
•
#1 Phillips head screwdriver
Not included but needed:
Image 37
1.
Remove the heater kit from the box
.
2.
Connect the heater cable to the connector on
PCB as shown in
Image 39
. Red is positive
(+) cable.
NOTE 1: MegaDome
®
2 Heater, MD2-HK,
uses 2.28 watts which is different from the
MegaDome
®
NOTE 2: Unlike the MegaDome
Heater. (MD-1HK is 10 watts)
®
Heater
(MD-1HK), MegaDome
®
3.
With the heater element facing away from the
main board in the camera, align the two (2)
holes on the heater board with the two holes
on gimbal base shown in
Image 38
.
2 Heater (MD2-HK)
doesn’t need external power input.
4.
Attach the heater board with the standoff on
gimbal base as shown in
Image 39
.
Image 38
Image 39
C
A
Heater
B
Connector
