Arecont Vision MegaDome
®
2 Installation Manual
2 |
P a g e
4.
If you are using the side conduit opening,
remove the conduit plug by first removing
the socket set screw using the provided
double-sided hex key
(Image 3)
.
Image 3
Note: Make sure that you install the rubber
gasket on the bottom of the camera to form a
weather tight seal with the mount surface.
5.
Run the Ethernet cable through the gasket
and the hole on the bottom of the camera
(Image 4)
or run the cable through the side
conduit and plug it into the RJ45 port.
NOTE:
If the camera will be powered via PoE, please
skip to step 6.
6.
If the camera will be powered by an AC or DC
power supply, run the supplied power cable
through the gasket and the hole on the bottom
of the camera or run the cable through the
side conduit and connect it to its respective
connector inside the camera
(Image 3)
.
NOTE: Make sure that your installation of
wires complies with Electrical Code of the
local government where the camera is
installed and that no bare wires are exposed.
Image 4
7.
Align the holes in the camera with the
prepared holes on the mounting surface.
Attach the camera to the mounting surface
with the wood screws or any optional
hardware suitable for the mounting surface.
8.
Use appropriate mounting accessories to
ensure a water tight installation. Use of silicon
does not guarantee a water resistant install.
HOLE
POWER
RJ-45
