Arecont Vision MegaView
TM
Installation Manual
3 | P a g e
Image 6
5.
Plug Ethernet cable into the MegaView
TM
PoE
Female RJ45 connector. (
Image 7)
NOTE: MegaView
TM
cameras are all PoE
only; Auxiliary power input does not support
camera but IR illuminator, heater and blower.
Image 7
Connecting External Power for IR Illuminator,
Heater and Blower.
6.
To use IR Illuminator, heater and blower,
connect auxiliary power t 12~48VDC or
24VAC. (
Image 7)
NOTE: Auxiliary power is always required if
you are using a heater / blower or IR LED.
NOTE: MegaView
TM
cameras contain heater /
blower. Heater and blower switch on 4C°
(39.2 °F), Off: 7°C (44.6 °F)
NOTE: Table 2 shows IR Illuminator Key
Parameters.
Key Specs
IR Leds
48 pcs
IR Wave Length
850nm
IR Distance
25 meter
IR Angle
45°
Power
3 Watts
Table 2
Connecting Digital I/O: (optional)
7.
To use digital I/O, connect digital I/O with
pigtail cable. (
Image 7)
NOTE:
MegaView
TM
DN version supports
both digital input and output; IR version only
supports digital input.
Electrical
Characteristics:
Min
Max
Camera
Input voltage (V)
(measured b and –
ON
2.9
6.3
IR & DN
Versions
Digital In
Digital Out
Auxiliary Power
for Heater, Blower
and IR Illuminator
PoE RJ45
