3/8
USER'S MANUAL
BEFORE STARTING
Remove the product from the shipping carton,
checking that all the components supplied are
present in the box. Refer to the following packing
list to check which components must be present
in the packaging. If any component is missing or
damaged, contact your Arena Luci dealer
immediately.
n° 1 dimmer pack CO670L
Before starting the installation of your product
make sure that there are no evident damages
caused by transportation. In the event that the unit
is damaged, do not plug it in and do not attempt to
use it until you contacted your Arena Luci dealer
for assistance.
INTRODUCTION
This unit is intended to dim the following type of
fixtures: incandescent lamps, halogen lamps, low
voltage halogen lamps with ballast.
To ensure the normal total working hours of this
dimmer pack, please observe the following
suggestions.
If dimmer pack is installed in a rack, make sure
the rack has adequate ventilation. Otherwise the
unit will become overheat and will result in a
malfunction.
The maximum output current of each channel is
10A: this is a testing condition and must be held
for 30 minutes maximum.
If the output current of each channel is less than
8A, the unit can work for several hours in
Theaters, Stages and Studios.
If the output current of each channel is less than
8A, the unit can work 24/7 without switching off in
Hotels, Restaurants, Buildings.
This dimmer pack provides 6 dimming channels.
Each output channel has a 10A magnetic circuit
breaker.
The unit is equipped with a thermalcontrolled fan.
When the temperature is over 45°C, the fan will
start automatically.
The auto tracking of frequency and phase enables
stable dimming output in different frequencies.
The unit provides a testing function to perform
tests without connecting to a console.
Preheat function to protect the loads (Warmup
setting is from 0% to 6%).
FRONT PANEL
(1) Power on/off switch
(2) DMX IN/OUT (XLR5 pin)
(3) DMX IN/OUT (RJ11, phone jack)
(4) LED display
(5) Function Keys
(6) Dimming sliders of channels 1 6
(7) Analog 010V input (9 pin)
(8) Magnetic circuit breakers
8
8
7
6
5 4
3 2 1
