2/4
TCK2337
GETTING STARTED
Open the shipping carton and verify that all
equipment necessary to operate the system has
arrived intact. Refer to the following packing list
for information on what items are included with
your model. If any equipment is missing or
damaged, contact your Arena Luci dealer
immediately.
n° 1 Boutique LED 51° TCK2337
Before beginning initial setup of your projector,
make sure that there is no evident damage
caused by transportation. In the event that the
unit’s housing or cable is damaged, do not plug it
in and do not attempt to use it until after
contacting your Arena Luci dealer for assistance.
INSTALLING THE DEVICE
Before carrying out any operation, remove the
mains voltage from the system.
The appliance can only be installed on electrified
tracks. Always make sure that the structure on
which you are fixing the appliance is safe and is
able to bear the weight of each unit.
Refer to the track installation instructions for
selecting the number of fixtures that can be
attached to the track.
The track adapter with which the spotlight is fitted
contains all the mechanisms for correct locking
and selection of the power supply line. It is
therefore necessary to become familiar with this
system in order to avoid damaging the adapter
and causing accidental falls of the equipment.
The track adapter has a side lever that serves to
lock the spotlight on the track. To be able to insert
the adapter in the track it is necessary to bring this
lever to a lateral position.
The electrified tracks are not symmetrical, but
have a protrusion on one side, since the insertion
of the various devices must take place in the
same way, so as to respect the polarity of the
three ignition lines 123. Insert the adapter into
the track, taking care to orient it as shown in the
figure.
To lock the spotlight in the desired position, move
the side lever parallel to the track.
To choose which ignition line will command the
spotlight, use the wheel at the bottom of the
adapter. The locking mechanism prevents the
wheel from moving until the side lever is parallel to
the track.
To select line 3 simply rotate the wheel to bring
the symbol 3 in correspondence with the arrow.
