4/8
LC9182SZG-RGB
S1
S2
S3
W
W+
3. Zigbee Network Pairing through Coordinator or Hub
(
Added to
a
Zigbee Network
)
LED indicator
Note: 1) After pairing successfully, the remote information will appear on the controller or hub interface.
2) No remote information will appear on the hub interface if pairing to Philips Hue Bridge.
Step 1:
Remove the remote from
previous zigbee network if it has already
been added to it, otherwise pairing will
fail. Please refer to the part "Factory
Reset Manually".
Step 2:
From your zigbee controller or
hub interface, choose to add device or
accessory and enter Pairing mode as
instructed by the controller.
Step 3:
Press and hold down until LED
indicator turns on.
Step 4:
Immediately short press to
search nearby network, indicator
flashes every 1 second, 20 seconds
timeout if there is no network. Indicator
will then blink 5 times quickly for
successful pairing.
4. TouchLink to a Zigbee Lighting Device
Note: 1) Directly TouchLink (both not added to a ZigBee network), each remote can link with 30 devices.
2) TouchLink after both added to a ZigBee network, each remote can link with max. 30 devices.
3) For Hue Bridge & Amazon Echo Plus, add remote and device to network first then TouchLink.
4) After TouchLink, the remote can control the linked lighting devices.
S1
S2
S3
W
W+
ZigBee Lighting Device
< 10cm
Step 1
: Set the zigbee lighting device to
start TouchLink commissioning, please
refer to its manual to learn how
.
LED indicator
Step 2
: Bring the remote within 10cm of
the lighting device
.
Step 3
: Short press any button to
choose a group to touchlink
.
Step 4
: Press and hold down until LED
indicator turns on
.
Step 5
:Immediately short press to
st
art
Touch
L
ink
c
ommissioning of the remote
.
LED indicator flashes fast for 3S, then
flash 6 times slowly to indicate successful
pairing to the device and the light
connected to the device will blink twice.
5. Factory Reset Manually
S1
S2
S3
W
W+
LED indicator
Step 2:
Immediately short press 5 times
continuously, indicator flashes 3 times
quickly to indicate successful reset.
Step 1:
Press and hold down until LED
indicator turns on.
Note: All configuration parameters
will be reset after the remote is reset
or removed from the network.
