5/8
USER’S MANUAL
6. Factory Reset a Lighting Device (Touch Reset)
Note
: the device shall be added to a network, the remote added to the same one or not added to any network
.
S1
S2
S3
W
W+
ZigBee Lighting Device
< 10cm
Step 1
: Set the zigbee device to start
TouchLink commissioning, refer to its
manual
.
LED indicator
Step 2
: Bring the remote within 10cm of
the lighting device
.
Step 3
: Press and hold down until LED
indicator turns on
.
Step 4
:Immediately short press 5 times to
start Touch Reset of the remote
.
LED
indicator flashes fast for 3S, then flash 3
times slowly to indicate successful reset.
7. Removed from a Zigbee Network through Coordinator or Hub Interface
From your ZigBee controller or hub
interface, choose to delete or reset
the remote as instructed, indicator
flashes 3 times quickly to indicate
successful removing.
S1
S2
S3
W
W+
8. Remove a Touchlink Paired ZigBee Lighting Device
ZigBee Lighting Device
< 10cm
Step 1
: Set the Touchlink paired zigbee
device to start TouchLink
commissioning, please refer to its
manual to learn how
.
LED indicator
Step 2
: Bring the remote within 10cm of
the lighting device
.
Step 3
: Short press the group button
that the device was linked to
.
Step 4
: Press and hold down until LED
indicator turns on
.
Step 5
: Immediately short press twice to
start TouchLink removing of the remote
.
LED indicator flashes fast for 3S, then
flash 6 times slowly to indicate
successful removing.
