6/8
PROMO 5 LED
ZOOM / FOCUS ADJUSTMENT
Zoom of the light beam and focus of the image
are obtained using the 2 knobs located on the
right side of the projector.
The beam spread can be adjusted from a
minimum of 20° (handles apart, see fig. A) to a
maximum of 40° (handles together, see fig. B).
RAIN COVER
The optional rain cover kit for outdoor installation
(code COVER150) consists of two forks and a
cover which, once fixed, almost completely
encloses the projector, to protect it reasonably
from a normal precipitation.
However, it is advisable to evaluate the intensity of
the atmospheric phenomenon, also in relation to
air currents that could bring water into the
ventilation slots, so as to decide to switch off the
appliance and avoid short circuits.
To be able to install the rain kit, the projector's
yoke must be in the bottom side.
Mount the two forks at the two ends of the
projector, on the top. The two forks have two holes
on each side, with different diameters so as to be
fixed only in the exact orientation.
On the left and right sides of the projector there
are threaded inserts used to fix the forks. Use the
M4x10 and M6x12 Allen screws provided to fix the
forks to the projector.
Position the rain cover over the forks, matching
the fixing holes of the cover with the holes in the
forks. The side with the opening must be in
correspondence with the lens of the projector.
Screw the cover by mean of the two M6x16 Allen
screws provided.
