25
English
Cleaning function ("Clean" function)
The appliance has an internal cleaning function. Proceed as follows to use the
cleaning function:
1.
The appliance should be in standby mode (power LED flashes). If this is not
the case, press the "POWER" button once.
2.
Fill the water tank with water if necessary.
3.
Press the "Select" button until the "CLEAN" LED lights up.
4.
Then press the "POWER" button to start the cleaning process.
5.
The appliance automatically runs a cleaning program, which consists of 6
individual cycles with a total time of about 8 minutes.
6.
Run the cleaning program again if the taste is not as fresh as expected.
Note: We recommend that you carry out the cleaning process first using a gentle
cleaning agent and then another cleaning cycle with fresh water to remove all
cleaning residues.
8. Troubleshooting
Error
Cause
Troubleshooting
"ADD WATER" LED
lights up
•
Low water level
•
Sensor is blocked
•
Pump is faulty
•
Fill the water tank
• Clean the sensor
•
Please contact our customer
service department
Summary of Contents for 20190828FS002
Page 66: ...66 Notes ...
Page 67: ...67 Notes ...