Only when the hardware is detected, you will see the hardware status
in the title bar of the main menu, for example: “COM X – SAM”. The
X shows the COM port on which SAM is detected. When you connect
the hardware later.
(ATTENTION: ALWAYS SWITCH SAM or MRAI OFF BEFORE
ATTACHING/DISCONNECTING IT TO/FROM A PC! OTHERWISE
SAM or MRAI AND THE PC MAY BE DAMAGED!
Usually this does not cause any damage, but it is saver to handle
it as described!)
, it is possible to detect it with a simple command.
There is no need to restart the software for hardware detection, just
click on the RED spot at the right side of the main menu bottom.
In the main menu the software language can also be selected.
. General purpose controlling program for SAM
The function of the SAM controller software is to switch the relay contacts
after an event (status change).
Fig. .. Controlling program
