Cleaning and Maintenance
Your hoop will inevitably accumulate dirt, scuffs, and scratches through normal use.
Surface dirt can be cleaned with a cloth, water, and dish soap. Be sure to keep water out
of the USB port and the battery area. ‘Goo Gone’ works well for removing stubborn tape
residue.
Deeper scuffs and scratches can be polished out using ultra-fine #0000 steel wool. Close
the hoop and tape over the seam and USB port first to avoid getting pieces of steel wool in
the electrical contacts, and wear gloves to prevent splinters. Wipe off any stray bits of
steel wool using a damp cloth. Fine grit sandpaper will remove even deeper scratches
from HDPE.
If there’s dust or dirt in the USB port or battery compartment, blow it out with compressed
air or ‘canned air’ duster spray.
The connector may become more difficult to open over time. If this happens, wipe it down
inside and out with rubbing alcohol to clean it. Your hoop comes with a packet of
petrolatum lubricant; a small amount rubbed on to the connector will make it slide more
easily. Wipe it on, close and open it a few times, and then wipe off the excess with a paper
towel.