Argo Service Manual Electrical System
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
ES-11
Installing the Lens Assembly (Conquest Models from CB12581)
1.
Install the rubber headlamp bezel into the headlamp opening. Photo ES-7
2.
Install the bulb into the headlamp housing. Insert and turn 1/4 turn clockwise.
Photo ES-8
3.
Snap the lens assembly into the rubber headlamp bezel.
ES-7
ES-8
Headlamp Removal (Earlier Vanguard2 & Vanguard Models)
On Vehicles manufactured prior to S8131 & SN8138:
1.
Remove the engine access cover.
2.
Disconnect the battery.
3.
Using a screw driver, remove the 4 screws holding the headlamp rim to the upper
body.
4.
Pull the headlamp from the body.
5.
Using a screwdriver, disconnect the wire leads from the headlamp.
6.
Inspect the rubber gasket seal.
Headlamp Installation (Earlier Vanguard2 & Vanguard Models)
1.
Seat the rubber seal into the headlamp opening in the vehicle.
2.
Fasten the wire leads to the headlamp with a screwdriver.
3
Seat the headlamp into the rubber seal and install the rim fastening it securely with
the 4 screws.
4.
Reconnect the battery
5.
Install the engine access cover.
