10
EN
CAUTION:
It is forbidden to place more sheets of paper / CD's / Credit Card then the maximum amo-
unt indicated by the producer. If the machine will be overloaded, then please proceed ac-
cording to the information given in the "paper jam" section.
MOTOR PROTECTION
The shredder is equipped with a motor overload device.
After 6 minutes of continuous work allow the unit to cool for 60 minutes before restarting.
If:
a)
the shredder is operated continuously for too long
b)
excess paper is fed in or the paper is not fed squarely into the shredder the overlo-
ad device may shut off the motor.
If any of this happens:
•
unplug the shredder and leave 15 minutes to cool
•
plug the shredder in, put the switch in (Rev), pull the excess paper from the cutters
and ensure the feed slot is clear
•
normal shredding may now be resumed.
CUTTER OILING INSTRUCTIONS
To ensure proper operation and function, periodic oiling of the cutting system is required.
Failure to oil your cutting system could result in reduced sheet capacity performance,
excess noise, paper jams and possibly machine failure. Oil your cutters every 5th or 6th
time you empty the basket, if excess squeaking and rubbing noise is coming from the ma-
chine or if the shredders sheet capacity has diminished.
Squeeze the lubricant across the full width of the cutters. Insert paper into sen-
sor to activate the cutting system forward for 3 seconds. Then press „REV” to make
shredder reverse for 3 seconds. Alternate between forward and reverse at least
three times or until all paper clears the cutters.
CAUTION:
Never use flammable synthetic oil, petroleum based or aero-
sol lubricants to oil your cutting system. Use only a vegetable oil based lubricant in
a non-aerosol container with extension nozzle.
BASIC EXPLOITATION RULES
It is not advised to cut as many sheets as indicated as the maximum capacity of the shred-
der. By exploiting the machine at it's top capacity we significantly reduce it's vitality.
Therefore, to maintain a durable and faultless work of the shredder, it is adviced to place
no more then 70% of the maximum amount of sheets to be shred at one time indicated
for each model by the producer. The maximum amount of sheet should be used only oc-
casionally.
© ARGO S.A.
www.argo.pl
