12
EN
CAUtION:
It is forbidden to place more sheets of paper then the maximum amount indicated by the
producer.
If the machine will be overloaded, then please proceed according to the information given
in the "paper jam" section.
FEEDING CREDIt CARDS/CDS
1. Plug in the machine and choose the reV/cD function.
2. Feed the credit card/ cD into the proper entry and the machine will start automatically.
CAUtION:
Never attempt to shred more than one credit card/cD at a time or the shred¬der will jam.
Never attempt to shred BOTh paper and credit cards/cDs at the same time. Doing so will
damage the shredder.
mOtOR PROtECtION
The shredder is equipped with a motor overload device.
After 2 minutes of continuous work allow the unit to cool for 30 minutes before restarting.
After cooling down, the shredder is ready to re-start to work. It is crucial to avoid the situ-
ation when the thermal fuse will work - this type of usage of the shredder is not proper and
implies machine's overwork.
CUttER OILING INStRUCtIONS
To ensure proper operation and function, periodic oiling of the cutting system is required.
Failure to oil your cutting system could result in reduced sheet capacity performance,
excess noise, paper jams and possibly machine failure. Oil your cutters every 5th or 6th
time you empty the basket, if excess squeaking and rubbing noise is coming from the
machine or if the shredders sheet capacity has diminished. squeeze the lubricant across
the full width of the cutters. Press the "I" button, insert paper into sensor to activate the
cutting system forward for 3 seconds. Then press „reV” to make shredder reverse for 3
seconds. Alternate between forward and reverse at least three times or until all paper
clears the cutters.
CAUtION:
Never use flammable synthetic oil, petroleum based or aerosol lubricants to oil your
cutting system. Use only a vegetable oil based lubricant in a non-aerosol container with
extension nozzle.
BASIC EXPLOItAtION RULES
It is not advised to cut as many shreets as indicated as the maximum capacity of the
shredder. By exploiting the machine at it's top capacity we significantly reduce it's vitality.
Therefore, to maintain a durable and faultless work of the shredder, it is adviced to place
no more then 70% of the maximum amount of sheets to be shred at one time indicated
for each model by the producer. The maximum amount of sheet should be used only oc-
casionally.
© ArGO s.A.
www.argo.pl
