y
y
y
y
x
x
x
x
Assembly Instructions
13
Step
21
Fit the 2 back panels
a:
Square up the unit by
making sure that
measurement
x:x equals
y:y.
Place the small back
and large back ,
coloured surface facing
down, onto the unit as
shown.
Make sure that the 2
backs are pushed up
tight against each other
and that they meet in the
centre of the divider’s
back edge.
b:
Nail around the
outside edges of the 2
backs.
Note:
Do not nail where
the 2 backs meet.
c:
Push the nail screws
. through the back
holders and tap them
down between the small
back and large back
. and into the back
edge of the divider .
Keep tapping the nail
screws in until the
back holders dig into
the small and large back.
Carefully stand the
unit up for the next
step.
16
17
E
O
P
16
17
12
O
P
Note:
If ever you need to take
the backs off to dismantle the
unit, the nail screws can be
taken out using a screwdriver.
O
P
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
Note:
These can
also be round
P
O
+
c:
O
P
16
17
P
b:
E
16
17
Warning:
The
unit is heavy.
Lift with care.
