PROGRAMMING YOUR PIN NUMBER
(personal identification number)
Each time a button is pressed, a beep will be heard and the Orange LED will flash. This is a
safety feature so that you will know when the safe is being accessed and cannot be switched off.
Keep PIN Codes in a safe place.
Do not use personal information like birthdays, telephone
numbers etc.
Security cap
covering reset
button
If the Red and Green LED light simultaneously when the correct PIN is entered, then
the batteries MUST be replaced immediately before closing the door as this indicates
that the batteries are too low.
If an incorrect PIN is entered, the safe will not open. Three warning beeps will be heard,
the Orange LED will flash and the Green LED won't light. Entering an incorrect PIN
three consecutive times will freeze the locking mechanism and keypad for 20 seconds,
during which time you will not be able to access the safe. After three more incorrect PIN
attempts, the locking mechanism and keypad will freeze for 5 minutes during which
time you will not be able to access the safe.
• Write down your PIN code so you do not forget it. (any
combination of numbers from 3 to 8 digits)
• With the door open, install 4 AA batteries provided.
• Depress the red reset button located at the back of the
door.(dia.2)
• The Orange LED will light.
• You now have 20 seconds to enter your PIN.
• Key in your new PIN.
OPENING THE DOOR USING YOUR PIN NUMBER
Each time a button is pressed, a beep will be heard and the Orange LED will flash.
While the door is open familiarise yourself with the door opening procedure and leave the door open
until you are satisfied that you fully understand the opening and closing method. You can re-set the
PIN at any time by following the above procedure.
• Press the "#" or "*" button once to finish.
• Two beeps will be heard and the Orange LED will go out.
• Your PIN has now been set.
• Screw the security cap back onto the red button. Ensure you do this for security reasons.
• Input the PIN you set.
• Press "*" or "#" button. The green LED will flash.
• Turn the knob clockwise to pull open the door.
Dia.2
