7
Open the battery cover (9) with a Philips screwdriver and insert 4 x 1.5 V AA
batteries(Do not provided with this product) into the battery case (8). Check that
the batteries are correctly fitted. Replace the battery cover and fix it with a Philips
screwdriver.
If the batteries run out during use, you can connect a power bank via the
connector (11) and so continue barbecuing.
As this item is packed in assembled status. Thus, there is no necessary for users
to assemble.
1. Place the inner bowl(6) into the outer bowl(7).
2. Fill the charcoal container(4) completely with charcoal.Put cover(3) on charcoal
container(4).
3. Apply a circular layer of lighter gel on ignition plate(5), approx. 10 mm (0.4
inches) wide.
4. Place ignition plate(5) into inner bowl(6).
5. Turn on the Switch(10) on side of battery case(8).Turn it clockwise to maximum
position.
6. Using a safety lighter, light gel until it burns.
7. Put the cover(3) on the filled charcoal container(4) and place container on
ignition plate(5). Within a short period of time, the charcoal should start
glowing.
Preparation
Assembly Instructions
Use
