13
Loading Ribbon
Note:
Thermal Transfer printing requires media to print with
appropriate ribbon. This section can be referred to, for X-Series
to use transfer thermal printing. The sample steps below are
based on ribbon wound ink-side in as an example. (X series
printers use ribbon wound ink-side in as default. To change setting
to ribbon would ink-side out, refer to Section - Switching Ribbon
Wound Ink-side out or Ink-side in)
1. Lift the top cover and front access door to expose the media
compartment. (Figure 1)
2. Turn the head latch counter-clockwise and open the bracket.
(Figure 2)
1
Summary of Contents for X-2300
