E T V I S I O N M A N U A L
9
An adjustable belt supplied with system threads through two removable “loops” on the Controller
Case and can be used hold the Controller on the participant's waist. The Controller “loops” are each
attached to the case with two screws. The screws can be loosened to remove or install the belt.
The Controller contains a Lithium Polymer battery. The battery charges whenever the provided DC
power supply is connected to the Controller power connector and plugged into an AC socket. The
power unit supplied with the system is equipped with the appropriate AC adapter for the AC power
specifications of the intended destination country. The system can be run using the DC power supply
even when the battery is fully discharged, however the battery will charge most rapidly when the
system is idle. When fully charged the battery will power the system for about 5 hours when all
system features are being used. The battery will recharge in about 4.5 hours when the system is idle.
3.3
ETVision
PC
ETVision
systems usually include a laptop PC running Windows 10 (“ETV PC”). When supplied by
Argus Science, as part of the ETVision system, the
ETVison
software application is pre-installed by
Argus Science. If the
ETVision
PC (“ETV PC”) is not supplied by Argus Science see Appendix E
(section 8.5) for required PC specifications and software installation instructions.
The ETV PC laptop includes WiFi capability, a LAN port, USB ports, and an SD card slot. The
ETVision system uses micro SD cards. Micro SD cards must be placed in a micro-to-standard SD
card adapter before inserting in the SD card slot on the ETV PC.
If the ETVision PC was supplied by Argus Science as part of the
ETVision
system, the
ETVision
application will be set to “load as administrator”, and both the ethernet and WiFi will be set to obtain
IPv4 address automatically. The PC should automatically connect to the controller via the LAN port
if a cable is connected or via WiFi if a cable is not connected. If the ETVision PC was not supplied
with the system, or if the
ETVision
app is reset to not have administrator privileges, see Appendix E
for LAN setup instructions.
