EN - 13
1. Check fuel level and add fuel if needed.
IMPORTANT:
Use fresh unleaded fuel with
an octane rating of at least 87. DO NOT use
E85 blended fuels; the engine is not E20 /
E30 / E85 compatible. The maximum
recommended ethanol content is 10%. Ariens
recommends using a quality fuel stabilizer in
all fuel. See
2. Check engine oil level and add oil if
needed. Refer to engine manual.
3. Check hydraulic oil level. See
4. Check condition of air cleaner. Refer to
engine manual.
5. Check function of all controls.
CHOOSE WORK SITE
1. Set up log splitter in an area that
provides:
• A dry level surface.
• Good footing that is free of debris or
other tripping hazards.
• Sufficient clearance for engine exhaust
to not blow directly on combustible
material.
2. Disconnect the log splitter from the tow
vehicle before operating. If splitting logs
in the horizontal position, move rear
stabilizer to work position. See
on page 14. Chock the wheels to
prevent movement during operation.
POSITION REAR STABILIZER
1. Remove hair pin from upper lock pin and
slide lock pin out from brackets.
2. Rotate rear stabilizer up or down until
holes in stabilizer align with holes in
brackets.
IMPORTANT:
Rear stabilizer must be locked
in the transport position before towing unit or
before placing beam in vertical operating
position.
3. Insert lock pin all the way through
brackets and stabilizer.
4. Reinstall hair pin.
BEFORE OPERATION
Figure 14
1. Rear Stabilizer
2. Lock Pin
3. Hairpin
Operating Position
Transport Position
Summary of Contents for 017000
Page 29: ......
