GB - 11
CONTROLS AND FEATURES
See figure 7 for all controls and features
locations.
Engine Switch
The engine
switch has two
positions:
1. OFF – Engine
will not start or
run.
2. ON – Engine
will start and run.
Choke Control Lever
1.Choke Closed
position: chokes
off air to engine
for easier start.
2.Choke Open
position: allows
for normal
operation.
IMPORTANT:
Gradually open choke after
engine starts.
Throttle Control Lever
The throttle
controls the
engine speed. To
increase or
decrease the
engine speed,
adjust to:
1. Fast (normal or warm starts)
2. Part-Throttle
3. Slow (cold weather starts)
Fuel Shut-Off Valve
IMPORTANT: The fuel shut-off valve MUST
be in the closed position prior to
transporting the unit.
The fuel shut-off valve has two positions:
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT:
DO NOT let handle snap back
against starter.
Control Lever (Figure 9)
The control lever is used to move the splitting
wedge in or out when operating in the
horizontal position or up and down when
operating in the vertical position.
OPERATION
WARNING:
AVOID INJURY.
Read and understand the entire
Safety
section before proceeding.
1
2
2
1
3
2
1
Figure 8
Open Position:
Use this position
to run the unit.
Closed Position:
Use this position
to service,
transport, or
store the unit.
Figure 9
Horizontal Operating Position
Vertical Operating Position
3
1
2
3
1
2
